Shower Handpiece

How to install OxiJet™ for Shower Handpiece

Follow the below steps to install the shower hand piece available in Sydney

Instruction:

Card image cap

Remove any existing flow restrictor

Card image cap

Install the Oxijet™ and ensure the seal is attached between fittings

Card image cap

Ready to use


1. Unscrew handpiece from the hose.

2. Ensure there is no lime and calcium build up in the handpiece. Any restrictor after the Oxijet™ will reduce its effectiveness. Restrictors may include lime scale, or simply restriction in the handpiece or shower head itself.

* To remove lime and calcium build up: Soak handpiece in a water and white vinegar solution.

3. Screw the yellow Oxijet™ into the handpiece. The water flow should flow in the same direction as the arrow on the Oxijet™. Ensure any washer supplied is in place before securing the Oxijet™.

4. With the hose washer left inside the hose, screw the Oxijet™ and handpiece into the hose.

Note: The Oxijet™ is optimised for Felton shower handpieces and DIN EN1113 rated hoses. Only use with non-restrictive (all pressures) handpieces. Do not use non DIN EN1113 rated standard hoses and may not be compatible with some handpieces.

Operating pressures: Minimum 300 kPa | Maximum 1000 kPa
Operating temperature: Maximum 80°C
TOP